Champion Grinder Pump - 1HP - 115V - 2" Discharge

Description

Features and Benefits
Flow
up to
42 GPM
and
Heads
up to
55’ TDH
High efficient, oil-filled motor with upper and lower ball bearings and thermal overload protection. Provides maximum motor cooling, which helps the pump last longer.
Cutter Technology
The shredding ring and radial cutter shall be constructed of 440 SST (Rockwell 56-60) reversible cutter assembly. With 24,000 cuts per second and 1.5 million cuts a minute. Combined with a cast iron vortex impeller, which helps provide you a superior pump that prevents overloading and also prevents the pump from clogging
Plug
Sealed entry, quick-disconnect power cords, 30’ with a plug. This design allows the pump to be easily replaced in the field and prevents water from entering the motor housing through a cut cord
Piggy-Back switch design that allows the pump to be operated manually by overriding the switch. Pump and switch can easily be diagnosed over the phone
Discharge:
2” NPT. Vertical
Liquid Temperature:
140 Degrees F. (Intermittent)
Motor Housing:
Cast Iron
Volute:
Cast Iron
Impeller:
Cast Iron/Vortex
Seal Plate:
Cast Iron
Shaft:
416 Stainless Steel
Shaft Seal:
Type 21 Carbon Ceramic, Buna-N-Elastomer, 300 Series Stainless Steel Hardware
Bearing (Upper & Lower):
Single Row, Ball, Oil Lubricated
Hardware:
300 Series Stainless Steel
O-Rings:
Buna-N
Cord:
20’ With Plug. UL/CSA (SJOW) 14/3 (.375 OD). Quick disconnect pin terminals.
Motor (Single Phase):
3450 RPM. 60 Hz, NEMA L, Includes overload protection in the motor, Oil filled, Class F, Capacitor start/capacitor run.