-40%
Useful Arts BF-1 Tube Instrument Preamp/DI (UAA-BF1d2)
$ 379.68
- Description
- Size Guide
Description
Your Holy Grail DI for Bass and GuitarSweetwater is an Authorized Useful Arts Dealer
Genuine Open Box Item
Sweetwater's 2-year warranty
Useful Arts BF-1 Tube Instrument Preamp/DI
Tube Instrument Preamp/DI with 20 Million Ohms Input Impedance, Class a Tube Preamp, 2-band EQ, Low-gain/High-gain Operation, Thru Jack, and Balanced/Unbalanced Outputs
Your Holy Grail DI for Bass and Guitar
If you think of direct boxes as utilitarian devices designed to get an XLR-compatible signal out of a bass or guitar, then Sweetwater has a nice surprise for you. Enhancing clarity, detail, and dynamics, the Useful Arts BF-1 goes way beyond basic DIs. A do-it-all interface for any instrument with a pickup, the BF-1 is used between instrument and amp, instrument and PA or recording device, or all of the above. Everything you plug into it instantly sounds better — not because it changes the sound of your axe, but because it preserves the native sound of an instrument more effectively than any amp or console input stage. You'll be amazed at how good the Useful Arts BF-1 will make your instrument sound.
It all comes down to input impedance
So what's the story? The signal output by magnetic pickups is gorgeous, highly detailed, and pitifully weak — piezoelectric pickups even more so. It's not simply a question of signal level (voltage); what's at issue is the
power
of the signal (current). All amplifiers make signals work to drive their input stages. The problem is that the most nuanced (the weakest) parts of the signal aren't up to heavy lifting and are lost forever. It all comes down to input impedance.
20 million ohms
The higher the input impedance, the less work a signal has to do in order to be amplified. The typical input impedance of consoles and recording devices is usually about 10,000 ohms — much too low for a pickup. That's why a bass or guitar plugged directly in sounds small, lifeless, without detail and bottom end. Thin and buzzy, piezo pickups sound even worse. The input impedance of guitar and bass amplifiers is typically around several hundred thousand ohms — a major improvement that makes instruments sound bigger, fuller, and more detailed. This is why the traditional method for recording or live gigs is to run the instrument into a direct box for the console and back out to the guitar amp. The DI replicates the input impedance of the amp and converts it into a console-friendly signal. So far, so good. But Useful Arts takes the equation further. What if, instead of a few hundred thousand ohms, a DI had an input impedance of 20 million ohms? Enter the BF-1.
Using an input tube for massive impedance conversion
Setting out to design the BF-1, Useful Arts determined that tubes — as they are inherently capable of creating ludicrously high input impedances — were uniquely well suited for the job. Passive DIs utilize transformers, which cannot effectively create such high impedances. Active DIs employ low-voltage FETs, which sound like, well, transistors, and typically offer input impedances far lower than a good tube stage to boot. The BF-1 uses its input tube the same way a tube microphone does — to convert impedances in the absence of high gain. Even your tube guitar or bass amp sounds better when fed from the BF-1, courtesy of a better-sounding signal at its input.
But wait, there's more…
Massive impedance conversion is impressive, but the BF-1 isn't a one-trick pony. Also onboard are a Class A tube preamp, a 2-band equalizer, and two outputs you can use to simultaneously feed your amp and console. But there's even more. Bypassing the EQ gives you a choice of low gain (like a conventional DI) or high gain, which lets you go straight into converters for purist hi-fi line-level recording — no other amplification required. For bassists, the BF-1 can negate the need for an amp altogether. Feed a console with the tubes in the BF-1, and it will rival or exceed any bass amp you've ever used. Crank the EQ's low band and kiss the venue's windows and drywall goodbye.
Useful Arts BF-1 Tube Instrument Preamp/DI Features:
Input impedance of 20 million ohms
Class A tube preamp
2-band equalizer
Output gain control
Lo Gain or Hi Gain operation
Pure mode for hi-fi line-level output
Front-panel Input and Thru jacks
Rear-panel balanced XLR and unbalanced 1/4" jacks
Specification
Detail
Type
Active DI Tube Preamp
Channels
1
EQ
2-band EQ
Inputs
1 x 1/4" (Hi-Z)
Outputs
1 x 1/4" (unbalanced), 1 x XLR (balanced), 1 x 1/4" (thru)
Power Source
Standard IEC AC cable
RETURN INFORMATION
We want you to be completely happy with your purchase from Sweetwater. If you are not satisfied with your product, you may return it for a refund of the purchase price within 30 days. If your purchase was eligible for Free Shipping, the shipping cost will be deducted from your credit or refund. Returns must be in the complete and original packaging with all accessories and complete documentation (Owner's Manual, warranty card, quick start guides, etc.), show no signs of wear or use, and include a Return Authorization number or be subject to a restocking fee.
Fast, FREE Shipping!
Nearly every order received by 3PM Eastern ships the SAME DAY!
FREE shipping to lower 48 states.
Our central location reaches most states in 1-4 business days
99.95% warehouse accuracy
We are proud to provide some of the fastest turnaround times on eBay. We use FedEx or UPS for most items, and USPS for smaller items. Residents of Hawaii, Alaska, and Puerto Rico should contact us for a shipping quote.
PLEASE NOTE:
We cannot ship large items to PO boxes, please provide an alternate address. If you have questions, feel free to contact us.
Buy with confidence!
Sweetwater's been selling on eBay since 2001, with 99.9% positive feedback!
More than 30 years in business
World-class customer service
Fast, FREE shipping
Free 2-year warranty on nearly every product
Free tech support from audio experts